Upper Arm Classwork 3/29/22Finished Upper Arm Classwork p2 3/29/22Upper Arm Classwork 4/1/22Lower Arm Homework 4/4/22Extruding Lower Arm and Making Discs Homework 4/5/22Assemble Lower Arm and Metal Plates with Joints Classwork 4/5/22Create Correct Lower Horizontal and join with Lower arms AND add Screws 4/8/22 HomeworkInsert Parts into 360 Fusion 4/8/22 ClassworkLamp Base 4/11/22 HomeworkLower Horizontal- Circle and Square Cutouts 4/11/22 ClassworkRecreate Base Plate, Create Verticals, and Cut PlateConnected all Joints Together, COMPLETED
Hand Sketch of Phone with Dimensions Classwork
Orthographic Phone HomeworkStarted Extrusion of Phone and added side buttons Classwork
4/22/22 Homework and Classwork Almost Complete Model
Finished Bottom of Phone- Finished all ExtrusionsPhone Stand Model so far5/6 Classwork- Creating Bulb and Socket for Lamp.4 Concept Sketches- 5/10 hwCompleted Top, sides and Base (Classwork 5/10)Nuts, and Posts completed (Hw 9/12)Classwork of cut and sanded parts- however must redo because dimensions are too small and missing vertical (5/13)HW Completed base of lamp (5/14)5/14 Classwork Glued magnets to arm sides for both upper and lower arms and metal to verticals5/14 Classwork also recut base and horizontals becuase previous version was not the right size
I have fully completed my entire design of my lamp, making sure to have all pieces of wood able to be cut from the wood available, which is .21 in in thickness. Becuase of this, I can’t do any more homework because all I have left is to construct the previous lamp out of wood. If i have time, I would like to make this lamp out of wood to, as it is a simple design to cut out but still looks great.
5/17 Classwork- glued horizontals to sides of arms and clamped them togetherRecut Horizontals because I glued the wrong metal to themHW 5/20 Remade base to allow room for nutHW 5/20 added a third base for room for the wireConnect lower arm to upper armGlue verticals to baseAdd LED to Upper ArmClasswork 5/20 Connected Lower arm and upper arm with joint, glued metal to verticals, glued verticals to base, and attached LED5/25 Classwork- Connect Lower Arm To Verticals5/25 Classwork- Sauter Wires together5/25 Classwork- Covered Wires in Rubber5/25 Classwork- Glue top of base to bottom of base5/25 Classwork- Inspiration For Phone Stand5/25 Classwork-Concept Sketch of Phone Holder5/27 Homework- Suction for Phoneholder5/25 Classwork- Base for Lower arm5/25 Classwork- Base to Joint 15/25 Classwork- Joint 1 Plate5/25 Classwork- Join Plate 1 to Joint 15/25 Classwork- Joint 1 Arm5/25 Classwork- Joint 2 Arm5/25 Classwork- Cut out half slab joint from arms5/25 Classwork- Cut out Joint 1 to Base5/25 Classwork- Joint 2 Extrusion5/25 Classwork- Joint 2 Extrusion and Join with Plate 25/25 Classwork- lengthen Joint 2 second arm5/25 Classwork- Cut out Joint 2 to Phone Holder5/25 Classwork- Extrude Phone Holder5/25 Classwork- Final Phone Stand
Lville Design 